Rackem Single Hook Rack Review – etrailer.com


Today on our enclosed trailer, we’re going
to be installing the Rack ‘Em single-hook rack for enclosed trailers, part number RA-8. You’ll see here on our particular enclosed
trailer, the wires run right across the top lip, where the single-hook rack would actually
hang, so we’ve gone ahead and purchased a 2 x 6 x 8 board. We put an angle cut on the back side of it,
where the hook will rest against it, as you can see here by our small demonstration piece. By doing this, it will allow you to move the
hook the full length of the 2 x 6 x 8, as well as not damaging any of the wires that
rest across the top lip of our trailer. Now we’re ready to install our 2 x 6 x
8. We’ll take our level first and get a nice
straight line so that we put our board level. To do this, we use some wood screws, as well
as a couple metal screws to tie into the framing of
the trailer.

Leave a Reply

Your email address will not be published. Required fields are marked *