Mustang SR Performance Caster Camber Plates (94-04 All) Review

Mustang SR Performance Caster Camber Plates (94-04 All) Review


Hi I’m Justin with AmericanMuscle.com, and
I’m taking a closer look at the SR Performance Caster/Camber plates, fitting all 94-04 Mustangs.
If you’re thinking about lowering your car, then your alignment might be a potential issue,
depending on how low you go, you may not be able to get your car back into factory specs,
without the help of something like these plates from SR Performance. This kit allows you to
properly dial in both your Camber and your Caster, which are two of the biggest areas
that get affected whenever you lower your car. Without addressing this, your car will
not only handle poorly, but you’ll also chew through tires much faster due to improper
wear. Taking a closer look at the plates themselves you’ll immediately notice the quality construction,
these plates have been CNC’d from a single block of Billet aluminum for superior strength,
and although not quite as important, they’ve also been finished off with a very attractive
satin finish, which is sure to look sharp under the hood. The install is a little time
consuming and will involve you pulling the strut arm down the get the strut out of the
strut tower. Although this can be done using some basic tools and a floor jack, expect
to spend about 3-4 hours completing the job. So if you’re looking for an affordable way
to get your alignment back in check after lowering your car, then you’ll want to check
out SR Performance Caster/Camber plates, available right here at AmericanMuscle.com

Leave a Reply

Your email address will not be published. Required fields are marked *