How to Replace a Back Bike Wheel | Bicycle Repair


The hardest part about taking off your wheels
is the back wheel. That’s usually because there’s a gear there,
or a couple gears. I’ll show you a quick and easy way to take
off your back wheel and then put it back on. You can also flip your bike upside down and
do this. I know that most people don’t have bicycle
stands at home or on the street. Once again, you’re going to take this lever
on your quick release and open it up. Further brake levers there might be a little
pin you have to pull out or a little cable. There’s a couple different kinds. The next thing you want to do is put your
chain all the way down to the highest gear, which is the smallest gear, the smallest cog. Shift it all the way down to the smallest
cog. Then you have your brake lever open. Then you can do the same thing you do with
the front. Just pull the quick release open, push the
wheel out, and you’ll see it kind of rolls over the derailleur. If it doesn’t roll over the derailleur, if
it’s a little bit stuck, what you can do is give it a little hit on the top or you can
pull your derailleur back, like that. It’s not going to hurt the derailleur as long
as you’re not flexing it too much.Then you pull it out. Now what you can do is put it back in by pressing
on the back of the derailleur. See how it opens up the chain nice and wide
there? Make sure that it’s shifted all the way down
to the highest gear, basically so there isn’t any tension on this cable here. Put the chain on that first gear. Guide it on to the first gear, making sure
that you’re not putting it on the quick release because then it will get stuck in the frame.Pull
it up completely straight. Make sure that you do the same that you would
do with the front. Nice and straight in the actual frame. Then you can turn down the quick release and
figure out where the best spot is. Make sure it’s tight enough, but not too tight. Spin the wheel to make sure it is sitting
properly in the frame. You can also spin the pedals to make sure
that it’s on the proper gear or you can spin it back up to what gear you had before so
when you get on your bike it’s not too hard to ride. Make sure you turn the quick release for the
brake back on and check it to make sure that it’s stopping properly. That’s how to take off your wheels and also
put them back on.

Leave a Reply

Your email address will not be published. Required fields are marked *