Homemade 200cc MOTORCYCLE of CAR TIRES !?  / PART 1

Homemade 200cc MOTORCYCLE of CAR TIRES !? / PART 1


Since I don’t have a turning tool, I had to get this made by a turner. So you can see what it should look like. It is the head for the wheel. Bearings, the axel and the disc for the break go here. The breaking system was provided by Banggood. I will leave a link for it in the description.

Only registered users can comment.

  1. Oi só uma coisinha errada nisso tudo, o tensor que tenciona a corrente esta colocado no lado errado, deveria ser na parte inferior da corrente, e não na parte superior onde da o torque da tração.

  2. Might want to rethink the muffler idea. Gonna end up melting your shoe. Maybe bring it up and behind the seat.

  3. talk about being built like a tank. in aisia, they are putting cub motors on a bmx bicycle. your bike has axles thicker than my truck.

  4. i loved everything, the only problem is that no suspention for the engine will make all vibrations go throw the chassis

  5. Вот блондинка снова валит. И тут нажму я на тормоза что бы знала что за крутизна.

  6. Seharus nya pemerintah Indonesia mbebaskan anak muda berkreasi bikin motor sendiri spt ini.
    Kalau tdk berani design sendiri sampek kiamat Kita tergantung sama Jepang.
    Dengan kata lain kreasi anak muda spt dibelenggu.

  7. Красавчик !!!! 👍👍👍👍👍👍👍👍👍👍👍👍👍👍👍👍👍👌👌👌👌👌👌

  8. Witam i pozdrawiam!!Super zbudowany motocykl wlasnymi rekoma,duza wiedza z tej dziedziny,dokladnosc daje zawsze dobry efekt,wrzucic troche koloru ,jakies oznakowania ,nalepki i bedzie wygladal jak kupiony,dobry pokaz filmu!!Tak trzymac!!

  9. Купил сварочный аппарат – вари всё подряд! Не обязательно качественно, прихватывай как придётся. А по технике… Натяжитель цепи – шедевр! Я уже лет в пять понимал, какую часть цепи натягивать надо! Глушитель – отдельная песня, пупурри из разных кривых обрезков труб. Ну а несоосные колёса – это полный треш! Надо было ещё сиденье сбоку от двигателя поставить, чтобы усилить ощущения дискомфорта своими руками!

  10. Hi Doc,
    Chain tensioner should be on the bottom chain, like a push bike with gears.
    Great job, looks like you enjoy what you do, keep up with the vids.

  11. And when the back sprocket is worn out you cant just trash the bike couse there's no way putting a new one in ( well you can grind off all the welding )…..

  12. I love your project motorbike. I hope it didn't break but tell me how long the weld held on the bottom frame to where it goes up at a 45 degree angle? The car tires are awesome, you got talent my good man.

  13. The dam thing is gonna overheat n blow up n before it blows up…it most probably will break in half 😂🤣😂

  14. congrates, creative mind, but try to improve your skill for professionally………really appreciate your talent……nice hobby

Leave a Reply

Your email address will not be published. Required fields are marked *