Draw-Tite Ball Mount Review – 2013 Ford Escape – etrailer.com

Draw-Tite Ball Mount Review – 2013 Ford Escape – etrailer.com


Today on our 2013 Ford Escape well be test
fitting the Draw Tite ball mount with three quarter inch rise or two inch drop, rated
at 6,000 pounds, part number 2923. Before fitting our ball mount to the vehicle
well need to get our hitch height measurement. To do this well measure from the inside top
edge of the hitch receiver tube to the ground. On this vehicle, that measurement is 14 inches. Keep in mind that measurement can change due
to hitch style, tire size or any other accessory that may change your vehicles ride height,
so its a good idea to measure yours. Well now go ahead and slide the ball mount
shank into the hitch, line up the hitch pin hole and install a hitch pin and clip. With that, our ball mount is secured to the
vehicle in the drop position. With the ball mount in the drop position from
the top of the ball mount platform to the ground measures 12 inches. We can now go ahead and flip the ball mount
into the rise position. In the rise position from the top of the ball
platform to the ground measures 14 inches. That will complete our test fit of the Draw
Tite ball mount with three-quarter inch rise or two inch drop rated at 6,000 pounds, part
number 2923 on our 2013 Ford Escape..

Leave a Reply

Your email address will not be published. Required fields are marked *