Draw-Tite Ball Mount Review – 2012 Honda Odyssey – etrailer.com

Draw-Tite Ball Mount Review – 2012 Honda Odyssey – etrailer.com


Today, on our 2012 Honda Odyssey we’ll be
test-fitting the Draw Tite Ball Mount 3/4-inch rise or 2-inch drop, rated at 6,000 pounds,
part number 2923. Now, to begin our test-fit, first, we’ll obtain
the hitch height of our vehicle. This is the measurement from the ground to
the inside top of the receiver tube. Our measurement is 11 inches. This measurement may vary to the tire size,
hitch style, or aftermarket accessories. Now, we’ll go ahead. In the drop position, slide the shank of the
ball mount into the opening of the hitch. Line up our pinholes, insert our pin through
our pinholes and secure the clip on the other side. We’ll then measure from the ground to the
top of the ball platform and we got a measurement of nine inches. Now, we’ll go ahead and put the ball mount
over into the rise position, repeat the same steps as before, and then measure from the
ground to the top of the ball platform. We got a measurement of 12 inches.

Leave a Reply

Your email address will not be published. Required fields are marked *