Convert-A-Ball Ball Mount with 8 Inch Drop Review – 2012 Ford F-250 – etrailer.com

Convert-A-Ball Ball Mount with 8 Inch Drop Review – 2012 Ford F-250 – etrailer.com


Today on our 2012 Ford F250 Super Duty we’ll
be test fitting the Convert-A-Ball Cushion Ball Mount for Two Inch Hitches with a 6-3/4
Inch Rise or 10 Inch Drop rated at 10,000 pounds, part number amsc8. Now before we begin our test fit we will first
need to obtain the hitch height of our vehicle. This is the measurement from the ground to
the inside top of the receiver tube.We’ll get a measurement of 21-1/2 inches. This measurement may vary due to tire size,
hitch style or any other aftermarket accessories. Now to begin our test fit in the drop position
we’ll simply slide the shank of the ball mount into the opening of the hitch and secure
the ball mount to the hitch with a pin and clip.We’ll now measure from the ground
to the top of the ball platform and we’ll get a measurement of about 14 inches. If the hitch height of your vehicle matches
the hitch height of our vehicle and your trailer ride height which is the measurement from
the ground to the bottom of your trailer’s coupler while it is level matches this measurement
this will be an appropriate ball mount for you.We’ll now flip the ball mount over
to the rise position and again measure from the ground to the top of the ball platform
and we’ll get a measurement of about 28-1/2 inches.

Leave a Reply

Your email address will not be published. Required fields are marked *